RES/OHMS INFO

Before you read through this, I would also recommend these sites if you want to know more about rebuilding.


  1. http://www.steam-engine.org/
  2. http://www.ohmslawcalculator.com/ohms_law_calculator.php
  3. http://vapez.fr/tools/coil/
  4. http://www.best18650battery.com/
  5. https://www.e-cigarette-forum.com/forum/blog-entry/list-of-battery-tests.7436/
Perhaps the most important thing when using mechanical mods is to make sure that your battery can handle the resistance of coil you build, for that I recommend this great site.

  1. http://www.kritikalmass.net/battery-calculator/



Please note that these charts are used as a rough guide only.






I'd like to thank Rob from stealthvape for the information on which these calculations were based and Gillian for the hard graft as always.


Comments

  1. Anonymous4 November 2013 at 14:20

    thanks man

    ReplyDelete
  2. Alex L11 November 2013 at 15:35

    Hi Todd,

    I've made a generic calculator for vape time. Note, this is based on exact numbers, so unfortunately it won't take into account 1) voltages lowering as battery voltage drops, and 2) VV/VW devices that boost battery power. So you should get a bit more vape time than the calculator indicates.

    https://dl.dropboxusercontent.com/u/20998810/Ecig/ecig%20calc.htm

    Hope it helps someone!

    ReplyDelete
    Replies
    1. Todd12 November 2013 at 03:25

      Outstanding work Alex, thanks for sharing that :)

      Delete
    2. Anonymous3 January 2014 at 09:26

      Thank you very much Alex L, I was looking for something like this for personal use as I continue to learn and experiment.

      Hope you don't mind but I copied it to my local system just in case the dropbox version is not available in the future. (for my personal use Only)

      Thanks again :)

      Delete
  3. Unknown26 January 2014 at 10:47

    Grill. Cheers Todd

    ReplyDelete
  4. Unknown26 January 2014 at 11:03

    Shared on UKVT Facebook Group - thanks Alex & Todd :)

    ReplyDelete
  5. Topper27 January 2014 at 10:58

    In the heading of columns with measured peaces (1cm, 1.5cm etc) must to be Ohm, not Ohm/m

    ReplyDelete

Post a Comment