When you make the micro coil, why dont you take that positive ring off and then feed the wick down the hole. then place the wire in the slot and put that ring down over your negative then over your wick and coil and screw it down. am sure it would be better that way
Looking to get this as my first RBA would you recommend going with what you used being the 3mm Silica Wick? also in your video you didn't mention the gauge of the wire, what have you found works best with this? Thanks
Hi Tood, Used your 3mm silica method with a twist, wrapped top few mms in mesh, works just as good as silica and with the mesh is a tad easier to coil. Well happy with it mate.....nice one. take care
When you make the micro coil, why dont you take that positive ring off and then feed the wick down the hole. then place the wire in the slot and put that ring down over your negative then over your wick and coil and screw it down. am sure it would be better that way
ReplyDeleteBecause I found it easier this way.
DeleteIt seems like it would leak having such a big wick hole and all the juice that goes into the middle. Have you had any problems with that?
DeleteNot a single leak yet.
DeleteHaving used this for a bit would you say it is worth the money?
ReplyDeleteOpinion hasn't changed since the review, still performing well :)
DeleteLooking to get this as my first RBA would you recommend going with what you used being the 3mm Silica Wick? also in your video you didn't mention the gauge of the wire, what have you found works best with this? Thanks
ReplyDeletestart off with .2mm as a rule of thumb and take it from there Dave :)
DeleteI love your videos. Is a doddle a good thing?
ReplyDeleteI doddle is a very good thing, means it's very easy :)
ReplyDeleteHi Tood,
ReplyDeleteUsed your 3mm silica method with a twist, wrapped top few mms in mesh, works just as good as silica and with the mesh is a tad easier to coil. Well happy with it mate.....nice one.
take care