The HERO APV

Watch "The HERO APV from charliesvapeshop.co.uk" on YouTube

Excuse the edits and confusion on materials, it is a stainless steel top section and the tubes are chrome plated brass.

Thanks too www.charliesvapeshop.co.uk for supplying the for review.

Comments

  1. Unknown20 May 2013 at 04:58

    Would be great for the missies but stick an 18650 tube on it and would bet fantastic for ME

    ReplyDelete
  2. Unknown20 May 2013 at 14:26

    you could pass a piece of kanthal thru the chamber hole then pass through the loops of wick then pass back thru chamber wet and pull

    ReplyDelete
    Replies
    1. Todd20 May 2013 at 14:29

      Great one, will share that :)

      Delete
    2. Anonymous23 May 2013 at 01:25

      I was thinking the same thing. Just use a loop of stiff wire from under the hole and use it to pull the wicks down. A straitened paper clip bent in half would work as a puller. They use something in fishing and sewing for threading hooks and needles just on a smaller scale. One at a time or all at once if the wicks fit. I'm in the U.S. and am very eager to get my Hero hybrid APV from the U.K..

      Thanks Todd

      Delete
    3. Anonymous23 May 2013 at 01:33

      Yes a paper clip straightened and bend into a long thin U shape would work as well. they use something like that for threading fishing hooks and needles but on a smaller scale. If you cant pull all the wicks at once one at a time should work

      Delete
  3. Andre Bregegere24 May 2013 at 15:30

    You can roll the end of the wicks together in a bit of SS mesh and fit them through the whole. Worked very well for me.

    I'm having trouble with this device with the wicking though, getting one dry hit after another. I used eight strands 1mm wick (as in your tutorial). Any tips?

    Anyhow, thanks for all your work Todd, I really enjoy your reviews :)

    ReplyDelete

Post a Comment